Installing a Brick Paver Walkway or Calcium Silicate Brick

The use of Bricks or Pavers to develop a walkway or patio matches a home in a way that is unmatched. In addition, setting up a Brick or Paver sidewalk does not necessarily need a pro.

The key to installing a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be set up. In addition, string lines ought to be strung on each side of the pathway.
Once the area has actually been dug down, 3/4" gravel stone ought to be laid in and tamped down tightly. The height between the tamped down sand and the stringline need to equal the thickness of the brick or paver.

Now that you have a steady base, put a 1" pipeline or journal board the length of the walkway on either side of the sidewalk. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will act as your pathway border and help to maintain the integrity and shape of the walkway.

The secret to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again help maintain the stability of the walkway.

Undoubtedly bricks/pavers will require to be cut or split when building the walkway. To actually cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you want to break the brick. If your pathway has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop up the outdoors edges with additional sand, and then shovel in the topsoil and pack down strongly.
Spread stone dust over the new sidewalk and sweep into the cracks. This will finish the interlocking of the bricks and assist to remove interlocking bricks any weed development.


In addition, installing a Brick or Paver pathway does not necessarily require a pro. The key to setting up a Brick or Paver Walkway is to very first properly prepare the area where the get more info bricks/pavers are to be installed. Now that you have a stable base, place a 1" pipeline or ledger board the length of the pathway on either side of the pathway. These strips will act as your pathway border and help to maintain the integrity and shape of the sidewalk. Undoubtedly bricks/pavers will require to be cut or split when building the walkway.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Installing a Brick Paver Walkway or Calcium Silicate Brick”

Leave a Reply

Gravatar